The ezCLIP universal stop clip for PCB magazine racks. The
ezCLIP system was created to allow electronics manufacturers who manually
load/unload PCB magazine racks a simple way to distinguish required spacing
between boards and to prevent damage on boards with taller components.
time, companies who operate without the ezCLIP system must manually check each
board when loading the PCB magazine rack to ensure that they are spaced
correctly. Failure to confirm correct spacing can lead to damaged components
that are critical to the board’s operation. With the ezCLIP installed on the
PCB magazine rack, companies can quickly identify which card guides should be
skipped as they prevent boards from being inserted. This allows for faster
set-up times for the production run and swift manual loading and unloading of
the boards during assembly, reflow, rework, inspection and more.
system offers the lowest cost option for safely marking board spacing on PCB
magazine racks for quick loading with the proper component height tolerances.
Single lane ezCLIPS are available in packs of 50 for $100.00. This package
would allow users to disable 25 lanes of the PCB magazine rack. Double lane
ezCLIPS also are available in packs of 50 for $150.00. The double lane clips
allow users to disable 50 lanes of the PCB magazine rack.
is manufactured from high quality spring steel and coated for long life use.
Installation is simple; just push the clip over the PCB magazine rack slot that
needs to be skipped. The bright finish is a visual cue that the cardguide slot
is not available and is easily distinguishable across a variety of electronics